Add To Favorate Print This Page Email This Page

Weight:0.90 KG

 

This Battery Analyzer is designed to test the condition of the automotive battery using conductance method. Unlike the conventional method of draining the battery by applying resistance load to it and obtain the result from the meter gauge; this analyzer utilizes a series of pulsed voltage across the battery cells and observes the AC current that flows in response to it.

 

Conductance correlates directly to the battery capacity

Passive testing method is safe.

Never discharges or drain the battery.

Able to test condition of discharged battery.

Consistent and repeatable results.

Provides unique indication of battery conditions.

 

Besides, this analyzer also provides check the Alternator's charging and Starter's cranking conditions.

 

It is maintenance free and no internal batteries required. It powers up when connected to the battery posts during testing.

 

Key Features

Simple and easy to use

Test batteries on and off the vehicle

Accurate results in milliseconds

Battery Life Analysis

Analysis Result : Good or Replace

Large easy to read LCD display.

Test results based on JIS, EN, DIN, SAE and IEC Standards.

Check Alternator charging conditions

Check Engine Starter conditions.

 

Functionality:

Test Result: Good or Replace

Capacity - Cold Cranking Amps (CCA), DIN, EN and IEC information relative to battery rating.

Internal resistance value (mΩ )

Life in percentage (%)

 

Use to test a wide range of 12V batteries (Starting [SLI], Deep Cycled and Marine) of Wet (Flooded), VRLA or Maintenance Free (MF), Sealed Maintenance Free (SMF), Absorption Glass Mat (AGM) and GEL cell. The major battery standards JIS, SAE, EN, DIN and IEC are supported.

 

System voltage: 12 Volts

Input voltage range: 9V~15V

Power requirements: No internal batteries required. Power on when hooked up during testing.

Testing range: 100 ~ 1700 CCA, 100 ~ 1000 DIN, 100 ~ 1000 IEC, 100 ~ 1700 EN

 

Test Time: Less than 5 seconds.